スリンガーの材料購入先、及び面取り加工方法変更前後の面取り部寸法は面取

スリンガーの材料購入先、及び面取り加工方法変更前後の面取り部寸法は
面取り幅については変更前後で大差ありませんが、面取り角度が
変更後のほうが小さくなっています。
これは、角度が小さいほうが面押し時の逃げが少なく、プレス加工時の圧力を少なく出来るため、
"工程能力を確保しつつ
角度を小さ目に狙っています。
"

結果 (英語) 1:

Material of purchase of the slinger, and is not much different before and after the change for
chamfer width chamfer chamfer dimension processing method before and after the change, but more of
after the change is smaller chamfer angle.
For better angle is small less escape of surface press time, it is possible to reduce the pressure of the press working at the time, this is, "You are aiming to smaller and the angle
while ensuring the process capability.
"

結果 (英語) 2:

The chamfer dimensions of Slinger materials suppliers, and chamfer processing how to change back and forth
is not much different before and after the change on the chamfer width, bevel angle
smaller than those after the change.
For this angle is smaller than the flank surface holding time less, be less pressure during press
"while maintaining the process capability
is aimed at small angles.
"

結果 (英語) 3:

As for the chamfering region dimensions of being mixed up, there isn't a wide margin about the
bevel face width the materials purchase of the Surin garfish and a chamfering processing method change in change front and back, but the
change back shrinks a chamfering angle.
This aims at a
angle into small pieces in order that there are few escapes at the time of the aspect push, and the one where an angle is small can reduce pressure at the time of the press working while finding ability in a
" process.
"