また、図2の場合は蒸発部胴板と仕切円筒の間の表面状態を点検出来ずGMP

また、図2の場合は蒸発部胴板と仕切円筒の間の表面状態を点検出来ずGMP上好ましくない構造である。さらに、熱交換部を蒸発室の内部に組み込む方式は蒸発缶の全長が長くなり、MWSの据付け高さが高くなることが難点である。

結果 (英語) 1:

Also, could not check the evaporation of body Board and transfer cylinder between surface condition figure 2 If the GMP preferably on no structure. Method, heat exchanger into the evaporation Chamber inside the evaporator length increases the high mounting height of the MWS is in.

結果 (英語) 2:

Also, a GMP undesirable structural can not check the surface condition between the evaporating section and the partition plate cylinder cylinder case of FIG. In addition, a method of incorporating a heat exchanger in the interior of the evaporation chamber the longer the total length of the evaporator, a disadvantage that the installation height of the MWS is high.

結果 (英語) 3:

In addition, in the case of Fig. 2 and the evaporation portion of the partition plate, the surface condition of the cylinder between the inspection could not be GMP on structure. In addition, the heat exchange portion in the evaporation chamber into the system, the overall length of the evaporator is increased, and the rise of the installation height of the MWS.