スリンガーの材料購入先、及び面取り加工方法変更前後の寸法は面取り幅につ

スリンガーの材料購入先、及び面取り加工方法変更前後の寸法は
面取り幅については変更前後で大差ありませんが、面取り角度が
変更後のほうが小さくなっています。
これは、角度が小さいほうが面押し時の逃げが少なく、プレス加工時の圧力を少なく出来るため、
工程能力を確保しつつ角度を小さ目に狙っているためです。

結果 (英語) 1:

Material of purchase of the slinger, and is not much different before and after the change for
chamfer width dimensions of the chamfer processing method before and after the change, but more of
after the change is smaller chamfer angle.
This is because for better angle is small less escape of surface press time, it is possible to reduce the pressure of the press during processing, it is aiming to smaller angles, while ensuring the
process capability.

結果 (英語) 2:

Dimensions of Slinger materials suppliers, and chamfer processing how to change back and forth
not much different before and after the change on the chamfer width the chamfer angle
smaller than those after the change.
For this angle is smaller than the flank surface holding time less, be less pressure during press
while maintaining the process capability is aimed to small angles.

結果 (英語) 3:

As for the dimensions of being mixed up, there isn't a wide margin about the
bevel face width the materials purchase of the Surin garfish and a chamfering processing method change in change front and back, but the
change back shrinks a chamfering angle.
This is because I aim at an angle into small pieces while finding ability in a
process in order that there are few escapes at the time of the aspect push, and the one where an angle is small can reduce pressure at the time of the press working.